Complete Set Original Side Assist Blind Spot Assist Cross traffic assist For Audi A6 S6 RS6 C8

Fit Car Model:

For 2019-2025 Audi A6 S6 RS6 avant allroad

Only suitable for vehicles with ACC!

Side assist

Package Contents:

2 * Side auxiliary rearview mirror cover (black)
2 * Lane changing warning lights
2 * Lane changing auxiliary module
2 * Module bracket
2 * Door module
1 * Wiring kit

Side assist+Cross traffic assist(Intersection assist)

Package Contents:

2 * Side auxiliary rearview mirror cover (black)
2 * Lane change warning light
2 * Lane changing auxiliary module
2 * Lane changing module bracket
2 * Cross auxiliary module
2 * Cross auxiliary bracket
2 * Door module
1 * Wiring kit

Function:

• BSD blind spot monitoring
• Real time monitoring of blind spot vehicles in the rearview mirror. If overtaking is detected in the rear, the corresponding side indicator light will remain on for warning.
• LCA lane change assistance
• When changing lanes and turning on the turn signal, if there is overtaking behind, the corresponding side indicator lights will flash continuously, indicating danger. Please do not change lanes
• DOW door opening warning.
• When parking and opening the door, if a car passes by on the side of the door, the system will flash an alarm, reminding not to open the door.
• RCW rear collision warning
• When the rear vehicle approaches rapidly with a rear end collision, the speed is greater than 50 kilometers per hour. The system will flash an alarm, indicating emergency preparedness.
• RCTA rear traffic crossing reminder
• When reversing and exiting the vehicle, if there is a vehicle passing through the rear, the system will flash an alarm, reminding not to continue reversing.

Note:

1.The delivered hardware has been functionally tested!
2.Installation instructions can be provided during installation, and the vehicle needs to be coded after installation.
3.Please contact your Volkswagen Audi dealer or modder to provide ODIS,5054A, 6154A, DOIP devices and diagnostic software.

Technical specifications:

Volkswagen and Audi Parts Protection and Coding Notice:
For some Volkswagen and Audi control modules, component protection (CP) and coding need to be removed after installation.
Removing component protection (CP) and encoding involves advanced online authorization and firmware /EEPROM write procedures, which must be performed using the official factory diagnostic system.

By purchasing this product, the customer explicitly acknowledges and agrees:

1. Removing component protection (CP) and encoding poses irreversible risks.
2. Incorrect programs, software mismatch, unstable voltage, session interruption or unauthorized tools may all cause the module to fail to be recognized, resulting in communication interruption or the module being unusable.
3. The Seller shall not be held responsible for any damage, malfunction, loss of communication or failure resulting from the removal of component protection (CP), coding, programming or vehicle system adaptation by the customer or any third party (including Audi dealers, workshops, modifiers or mechanics).
4. Any malfunction that occurs after the removal of component protection (CP) and coding is regarded as third-party technical damage after delivery and does not constitute a manufacturing defect. It does not meet the conditions for return, refund or replacement.
5. Special Note: If the customer requests the seller to remotely flash data and code for product coding and to remove component protection, please contact in advance. The remote cost will be calculated separately (the seller is responsible for any damage caused by this remote flashing of data and code).